Elite Roller Manufacturing

Patented Design

A green, sustainable idler solution.

Our reuseable four-bearing axle assembly allows the Elite roller to run up to three times longer than the competition. This also allows the roller to operate in more severe applicatons.

There is no welding involved. Two hubs are pressed together on a support tube, which is then pushed through the outer tube. The compression flange is then tightened on each end.

Each roller's damaged can is effortlessly replaced in a matter of minutes. In fact, any damaged part of the roller can be replaced. Purchasing only the replacement parts you need instead of complete idlers again and again translates into a major cost savings for our customers.